Checking Operation; Decorative Rear Trim Installation - Kenmore 79045482503 Installation Instructions Manual

Anti-Tip
mounting screws
2 oneachside
Decorative Rear Trim Installation
(if required)
1. Disconnect the power from the range.
2. Make sure the range is leveled.
3. Remove range from cutout opening.
4. Align the top of the decorative trim with the
countertop (Figure 8).
5. Make sure the top of the decorative trim is flushed
with the top of the countertop.
6. Using the screws provided fix the decorative trim into
the wall.
7. Drop the range back into opening taking care to
clear the anti-tip bracket and slide it to its final
position and reconnect the power source (the bottom
of the cooktop should be located over the decorative
trim).
Decorative Trim
/
Screw
Figure 8
Checking Operation
Some models have manual controls. Refer to the Use &
Care Guide and check all controls for correct operation.
Some models are equipped with an electronic oven
control. Each of the functions has been factory checked
before shipping. However, it is suggested that you verify
the operation of the electronic oven controls once more.
Refer to the Use & Care Guide for operation. Follow the
instructions for the Clock, Timer, Bake, Broil, Convection
(some models) and Clean (some models) functions.
Bake-After setting the oven to 350% (177°C) for baking,
the lower element in the oven should become red.
Broil-When the oven is set to BROIL, the upper element
in the oven should become red.
Clean (some models)-When the oven is set for a self-
cleaning cycle, the upper element should become red
during the preheat portion of the cycle. After reaching
the self-cleaning temperature, the lower element will
become red.
Convection (some models)-When the oven is set for
convection baking or roasting, both elements cycle on
and off alternately and the convection fan will turn. The
convection fan will stop turning when the oven door is
opened during convection baking or roasting.
iMPORTANT NOTE: A fan inside the upper rear part
above the oven (some models) provides additional
cooling of the oven electrical and electronic components.
The fan will continue to run after the oven has been
operating at high temperatures.
Model and Serial Number Location
The serial plate is located along the side of the oven
door in the open position.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your oveR.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use & Care Guide. It may
save you time and expense. The list includes common
occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use & Care Guide for Sears service phone
numbers, or call 1-800-4-MY-HOME _.