Table of Contents
Advertisement
Available languages
Available languages
4.
Gas supply pipe must be located within clearance area as
shown in the "Cabinet Dimensions" illustration in "Location
Requirements" section.
Complete connection
1.
Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A. Closed valve
B. Open valve
2.
Test all connections by brushing on an approved noncorrosive
leak-detection solution. If bubbles appear, a leak is indicated.
Correct any leak found.
3.
Remove cooktop burner caps and grates from parts package.
Align recess in burner caps with pins in burner base. Burner
caps should be level when properly positioned. If burner caps
are not properly positioned, surface burners will not light.
Place burner grates over burners and caps.
4.
Plug in range or reconnect power.
4 » Bsr, elie,
Be gabe
CS
g e m , C8
gegnes
souk p goad |
s i m , g r e , poght sor,
Verify Anti-Tip Bracket Location
Move range close to cabinet opening.
Remove cardboard or hardboard from under the range. Using
2 or more people, gently move range into its final location.
3.
To check that the anti-tip bracket is installed, use a flashlight
and look underneath the bottom of the range.
mg
Look for the anti-tip bracket securely attached to floor or
wall.
m
Slide range back so rear range foot is under anti-tip
bracket.
Level Range
Place oven rack in oven.
Place level on oven rack and check levelness of range, first
side to side; then front to back.
3.
If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket.
4.
Use wrench to adjust leveling legs up or down until range is
level. Push range back into position.
5.
Check that rear leveling leg is engaged in anti-tip bracket.
Check that the flexible conduit or power supply cord are not
bent.
NOTE: Range must be level for satisfactory baking performance.
VES pi gia Aer give, gi, gia, | ) p o e op AE yong yu, Go, y edo,
won
Electronic ignition Sysiem
Initial lighting and gas flame adjustments
Cooktop burners use pilotless igniters in place of standing pilots.
When the cooktop control knob is turned to the "LITE" position,
the system creates a spark to light the burner. This sparking
continues, as long as the control knob is turned to "LITE."
Check Operation of Cooktop Burners
Standard Surface Burners
Push in and turn each control knob to the "LITE" position.
The flame should light within 4 seconds. The first time a burner is
lit it may take longer than 4 seconds to light because of air in the
gas line.
If burners do not light properly:
m=
Turn cooktop control knob to the "OFF" position.
m
Check that the range is plugged in and the circuit breaker has
not tripped or the household fuse has not blown.
Check that the gas shutoff valve is set to the "open" position.
m
Check that burner caps are properly positioned on burner
bases.
Repeat start-up. If a burner does not light at this point, turn the
control knobs to "Off" and contact your dealer or authorized
service company for assistance.
17
Advertisement
Table of Contents
