Pantum CM9106 Series User Manual page 161

• A higher density is set when printing.
• The print head lenses are dirty.
Gray or colored
background
• The tray fails to load the media
properly.
Incorrect margins
• The printer does not support fonts
installed in the computer.
Jagged or
irregular
characters
• A lower density is set when printing.
• The print media does not meet the
usage specification. For example, the
print media is textured, damp, or too
rough.
• The resolution in the print program is
set too low, and the density is set too
Light print
low.
• The paper used has been stored in
the air for a prolonged time.
• The print head lenses are dirty.
• Toner Save set is checked.
• Please adjust the toner density from
"Print Preferences" or "Print" based on
your operating system, or adjust the
print density from the printer's control
panel.
• Clean print head lenses.
• Load correct paper. Please refer to
Section 2 for the way to load paper
correctly.
• please contact the customer services
center.
• Please correctly use the medium
conforming to the specifications. See
Section 2.
• Please adjust the toner density from
"Print Preferences" or "Print" based on
your operating system, or adjust the
print density from the printer's control
panel.
• Keep the paper in its original wrapper
before use.
• Clean print head lenses.
• Please do not check the Toner Save.
146