Table of Contents
Advertisement
262 Driving and parking
Combo 2 vehicle socket
Press the centre rear of the socket flap
#
and swing the socket flap forwards.
The indicator lamp
2
% and upper status
display
3
light up white.
%
The socket flap
1
can also be opened via the
multimedia system (
page 265).
/
Press catch
7
to the left and fold open
#
socket cover 5.
%
Connections
6
and
CCS charging cable connector. Both sections
of the socket cover must therefore be opened
5.
Fully insert the CCS charging cable connector
#
into the vehicle socket .
Make sure that the charging cable is not taut
when inserted.
The indicator lamp
display
3
flash orange, and green as soon as
the high-voltage battery is being charged.
When the charging cable is connected to the vehi-
cle, the vehicle cannot be started or moved.
At the start of the charging process, the charge
1
level display is shown in the driver display with a
charging prediction. The completion time either
refers to the predicted charge level at the set
departure time, or the time at which the high-volt-
age battery will be fully charged.
8
are required for the
4
# and lower status
F243 0059 02
%
Depending on the temperature, the fan and
battery cooling system may audibly switch on
during the charging process.
%
If the vehicle is idle for lengthy periods and
connected to the mains supply, the high-volt-
age battery will be recharged automatically as
needed or when electrical consumers are
activated (e.g. the pre-entry climate control).
Ending the direct current charging process (mode
4)
& DANGER Risk of death when charging at a
damaged socket
The charging process uses high voltage.
If the charging cable, the vehicle socket or the
mains socket are damaged, you could receive
an electric shock.
Only use an undamaged charging cable.
#
Avoid mechanical damage such as crush-
#
ing, abrading or driving over the cable.
Advertisement
Table of Contents
