Table of Contents
Advertisement
168 Seats and stowing
If the centre seat on the second row of seats
#
is not occupied: press the head restraint down
all the way.
Vehicles with a third row of seats
The head restraints on the third row of seats have
a usage position and non-usage position. The
usage position is the extended, top position in
which the head restraint engages; the non-usage
position is the bottom, retracted position of the
head restraint. If the seats on the third row of
seats are being used, the head restraint must be
in the top, engaged usage position.
When choosing a seat, bear in mind the limited
space available. With the seat in the correct,
upright position, your head should not touch the
roof lining.
If the third row of seats is occupied: move the
#
head restraints to the very top and have them
engage there.
If the third row of seats is not occupied: move
#
the head restraints to the very bottom.
▌Fitting/removing the rear seat head restraints
& WARNING Risk of injury due to head
restraints not being fitted or being adjus-
ted incorrectly
If head restraints have not been installed or
have not been adjusted correctly, there is an
increased risk of injury in the head and neck
area, e.g. in the event of an accident or when
braking.
Always drive with the head restraints fit-
#
ted.
Before driving off, make sure for every
#
vehicle occupant that the centre of the
head restraint supports the back of the
head at about eye level.
Do not interchange the head restraints of the
front and rear seats. Otherwise, you will not be
able to adjust the height and angle of the head
restraints correctly.
Adjust the head restraint fore-and-aft position so
that it is as close as possible to the back of your
head.
F243 0059 02
Removing
Release the rear seat backrest and fold it for-
#
wards slightly (
page 28).
/
Pull the head restraint upwards as far as it will
#
go.
Push release knob
1
in the direction of the
#
arrow and pull out the head restraint.
Advertisement
Table of Contents
