Assembly; Operation Pole Hedge Trimmer; Pivoting The Power Head - PrimAster PMTHS 600 Original Instructions Manual

ca. 5 cm
2

Assembly

There are three lugs inside the tube sleeve (A) on the
cutter head which must engage in the recesses in the
hexagonal tube. Place the device on a level surface as
shown in the figure below. The side of the hexagonal tube
in which there is only one recess must face upwards (B).
1. Slide the cutter head onto the tube in this position (to
do so, screw sleeve 14 must be loosened by turning
anticlockwise ( )). The lugs must engage audibly in
the recesses.
1
2. Tighten screw sleeve 14 by turning it clockwise ( ) to

Operation pole hedge trimmer

Pivoting the Power Head

The Pole Trimmer is equipped with a power head that
pivots. The power head has a spring-loaded button that
allows it to be locked into several different positions
within its 120-degree rotation. Before connecting the Pole
Trimmer to the electrical supply, make sure the power
head is locked into position. Do this by trying to rotate the
power head in either direction. The power head should
be locked in position and should not rotate. To pivot the
power head, follow the instructions below.
1. Push the round button (3) located on the side of the
GB-10
fasten the cutter head on the tube.
14
WARNING: Read and understand this owner's
manual before operating Pole Trimmer. Make cer-
tain you read and understand all Safety Warnings
of this manual. Improper use of this Pole Trimmer
can result in severe injury or death from fire, electric
shock, or body contact with moving parts.
Disconnect the pole trimmer from the power supply.
pivot bracket. The button is spring-loaded, so you will
feel some resistance when pulling it out.
A
B
14