Completing The Wizard Interface Tab Entries - Watchguard Firebox V10 Installation Manual

CHAPTER 4: Completing the Vcontroller Installation Wizard
2
If a 3 interface (DMZ2) is available, it cannot be put to use at this time.

Completing the Wizard Interface tab entries

To save your new Interface tab entries (no matter which model of
appliance you are configuring), follow these steps:
1
2
You should click Apply and then click OK if you want to continue to use
the Wizard after saving the newly configured interface addresses.
56
Click in the Network Mask field and type the correct entry.
When you have finished with the Interface tab entries, click Next to
proceed.
An informational dialog box appears, providing two options:
- Save Only (not recommended)
- Apply (recommended)
If Save Only is selected, click OK to proceed.
N
OTE
N
OTE
Vcontroller 3.2