Features Of The Appliance's Back Panel - Watchguard Firebox V10 Installation Manual

CHAPTER 1: A Tour of the WatchGuard Firebox Vclass Security Appliances

Features of the appliance's back panel

10
HA status LED
Console interface
Reset port
AC power
This light reports on the current status of this
appliance, if it is one of two connected as a high-
availability system. If this is the primary
appliance, and the light is on and steady, the
system is functional, and this appliance is on-line.
If this is the primary appliance and the LED is
blinking, a failover has occurred and the
secondary appliance is online. (That appliance's
HA LED should be steadily lit, indicating that it is
now the primary appliance.)
A single RJ-45 interface, labeled Console, permits a
direct workstation-to-appliance connection, at
which time you can use the WatchGuard
Command Line Interface (CLI) to configure and
administer this appliance. To learn more about
this administrative option, see the CLI Guide
chapter in the System Administration Guide.
This opening allows you to insert a straight pin or
paperclip and press an internal Reset switch that
restarts the appliance. This is an alternative to
unplugging and replugging the power cord.
This interface enables you to connect the appliance
(using the supplied power cord) to a 100 to
240VAC (50/60Hz) power source.
Vcontroller 3.2