Installing The Vcontroller (Solaris) - Watchguard Firebox V10 Installation Manual

You must activate your LiveSecurity Service to enable VPN 3DES
encryption or receive WatchGuard Support. To activate your LiveSecurity
Service, go to:
http:\\www.watchguard.com\activate
For more information on LiveSecurity Service, see the
Configuration Guide

Installing the Vcontroller (Solaris)

Before proceeding with the following, make sure you have all of the
network addressing information that will represent the Firebox Vclass
security appliance, including the IP address and accompanying subnet
mask that will replace the default addressing assigned to each of the three
data ports of the appliance–0 (Private), 1 (Public) and 2 (DMZ) interfaces
(where available).
BE SURE TO REVIEW the release notes that were included in this
package for information about Solaris-Java issues that you should be
aware of. For additional updates, be sure to check the WatchGuard Web
site.
To install the Vcontroller, follow these steps:
1
2
3
Installation Guide
Once the appliance has been discovered, you can immediately begin
the initial software configuration, as detailed in the following chapter.
, Chapter 2, Service and Support.
Insert the WatchGuard CD into the CD-ROM. (Under Solaris, the CD
should automatically mount at /cdrom).
Run this command:
cd /cdrom/watchguard
Now run this command:
./setup.sh
Installing the Vcontroller (Solaris)
N
OTE
N
OTE
Policy
33