Add Detergent, Close The Door And Set The Program; Addition Function Selection; Inlet Water Warning; Drainage Warning - Philco PLDI 148 AJW steam Owner's Manual

Add Detergent, Close the Door and Set the Program

Load the clothes to be washed in the drum and close the door. Add the detergent into the relevant
compartments for the type of program you are going to select, Add detergent as described in Detergent and
Additives section of User's Operation Manual.
1. Turn on the power.
2. Spin program selection button to required program, " off" must be passed through if pointer's initial position
is not "off''»startup.
3. Select washing temperature, spin speed by pressing "Temp", "Spin" buttons.
4. Press "Options" button to select additional functions.
5. After starting the program, display window displays program length (hours: minutes) and additional
function options in sequence.

Addition function selection

At standby state, press "Options" button to select additional function for current program. Select only one
function for each press, and then corresponding icon flashes. After starting up, program cannot be changed.
Pre-wash
Select the function to conduct pre-wash so as to enhance washing effects and better remove stains. This
function is suitable for heavy dirt clothes.
Before inflowing, laundry detergent/ washing powder can be added to pre-wash box, and washing powder
must be added to main wash box.
Extra Rinse
After set the function of rinsing adding, the program runs the rinsing process once again before running the
softening, and the total running time of the program increases accordingly.
Intensive
The function can be selected to prolong washing time, strengthen washing effects and better remove stain.

Inlet water warning

If tap is not opened, or water pressure is over low, display screen will prompt "F01" to give alarm.

Drainage warning

If the pipe is squeezed, drainage will not be smooth. In case of failing to completely drain for long time, display
screen will prompt "F03" to give alarm.

Door Lock Icon

After the program starts the Door Lock icon will light up and the door will be locked.
After completing program, door lock unlocks automatically.
During pause, if door opening condition can be met halfway, the door lock will unlock and its indicator light
will go out.
When door lock indicator light flashes, door shall not be opened forcibly so as to avoid personal injury.
EN - 28
Copyright © 2020, Fast ČR, a. s. Revision 08/2023