Qualification Required For Working With The Machine; Conversions And Alterations To The Machine; Safety Message Introduction - SANY STG190C-8S Safety, Operation And Maintenance Manual

STG190C-8S Motor Grader

2.1.5 Qualification Required for Working with the Machine

•
The equipment can only be operated by
trained and authorized persons who are at
least 18 years old.
•
The operator must fully understand and ob-
serve the operation rules of the equipment.
•
Persons under the influence of alcohol,
medication or drugs are not allowed to op-
erate, service or repair the equipment.
•
Only trained and qualified personnel can
carry out maintenance and repair tasks on
the equipment.

2.1.6 Conversions and Alterations to the Machine

Any modification to the machine without authorization from Sany may have an adverse effect on
the machine's performance or pose more serious hazard.
Improper operation or unauthorized application may lead to equipment failure, personal injury or
possible death.
Sany assumes no responsibility for such losses.
2.2 Safety Message
2.2.1 Introduction
The following safety decals and safety messages are used on the machine.
•
Make sure that you get familiar with the locations and information of all safety decals on the
machine.
•
All safety decals must be placed in the proper locations on the machine. They must be kept
clean for readability. Never use organic solvent or gasoline to clean the safety decals, which
could loosen the adhesive that secures the safety message. Loose adhesive will allow the safety
messages to fall.
•
Other signs are also on the machine besides safety decals and safety messages, which must be
kept clean and intact.
•
Use a new safety decal or safety message in a timely manner to replace the old one which are
damaged or missing.
WARNING
Safety, Operation and Maintenance Manual-March 2021
Fig 2-2
Safety
2-5