Download Print this page

Dräger Oxylog VE300 Quick Start Manual

Ventilator with optional carrying system holder
Hide thumbs Also See for Oxylog VE300:

Advertisement

Quick Links

Dräger
Drägerwerk AG & Co. KGaA, 23542 Lübeck
To our customers of the Dräger Oxylog VE300
Ventilator with optional carrying System holder
February 2019
Important Safety Notice!!!
Possibility of the Oxylog VE300 falling out of the carrying System holder.
Only devices specified in the attached serial number list are affected.
Dear Madam/Sir,
Within the framework of our continuous market surveillance activities, a case has come to our attention in
which the Oxylog VE300 Ventilator became detached from the wall-mounted carrying System holder. This
was because an axis was missing from the attachment mechanism on the bottom of the device. The missing
axis meant that the device was not firmly latched into the carrying System holder. No patient or user was
injured in the reported case. However, due to the weight of the device, it is not possible to rule out the risk of
injury if the incident were to recur.
The Oxylog VE300 Ventilators with carrying System can continue to be used safely. To do so, it is
necessary to attach the device to the carrying System holder as described in the Instructions for Ilse of the
carrying System holder, and to ensure in
particular
E
2.
that the device is correctly latched into
the carrying System holder and
3.
as a final Step to check that the device
is properly secured by pulling the
handle.
1.
that the device is inserted in the middle
of the socket (parallel to the wall-
mounted plate) and
Rh
The relevant excerpt from the Instructions for
Use can be found to the right:
1
Insert the device in the middle of the upper socket.
2
Press the device into the lower latch until it audibly clicks into place.
3
Make sure that the device is properly secured.
Drägerwerk AG & Co. KGaA
Moislinger Allee 53-55
23558 Lübeck, Germany
Postal address:
23542 Lübeck, Germany
Tel. +49 451 882-0
Fax +49 451 882-2080
info@draeger.com
www.draeger.com
Bank information:
Commerzbank AG, Lübeck
IBAN: DE95 2304 0022 0014 6795 00
SWIFT code: COBA DE FF 230
Sparkasse zu Lübeck
IBAN: DE15 2305 0101 0001 0711 17
SWIFT code: NOLADE21SPL
Company headquarters: Lübeck
Commercial register:
Municipal Court Lübeck HRB 7903 HL
General partner: Drägerwerk Verwaltungs
AG
Company headquarters: Lübeck
Commercial register:
Municipal Court Lübeck HRB 7395 HL
Chairman of the Executive Board of
Drägerwerk AG & Co. KGaA and
Drägerwerk Verwaltungs AG:
Stefan Lauer
Board of Directors:
Stefan Dräger (Chairman)
Rainer Klug
Gert-Hartwig Lescow
Dr. Reiner Piske
Anton Schrofner
VATID: DE135082211

Advertisement

loading