5730A
Operators Manual
Connect to Mains Power
To prevent shock hazard, connect the factory-supplied three-
conductor mains power cord to a properly-grounded power
outlet. Do not use a two-conductor adapter or extension cord,
as it will break the protective ground connection. If a two-
conductor mains power cord must be used, a protective
grounding wire must be connected between the ground
terminal and earth ground before you connect the mains power
cord or operate the Product.
Connect a 5725A Amplifier
The 5730A Calibrator provides an interface connector for the Fluke 5725A Amplifier.
Designate the active amplifier for voltage and current boost in the Setup Menu, as
detailed in Chapter 4. Refer to the 5725A Instruction Manual for the installation
procedure.
Connect a 52120A Amplifier
The 5730A Calibrator provides an interface connector for the Fluke 52120A
Transconductance Amplifier. Designate the active amplifier for current boost in a Setup
Menu, as detailed in Chapter 4. Refer to the 52120A Users Manual for the installation
procedure.
2-4
Figure 2-2. Line Power Label and Switch Location
XWWarning
hhp005.emf