Clean The Exterior; Connect To Mains Power; Connect A 5725A Amplifier; Connect A 52120A Amplifier - Fluke 5730A Getting Started Manual

Clean the Exterior

To keep the 5730A Calibrator looking new, clean the case, front panel keys, and display
with a soft cloth slightly dampened with either water or a non-abrasive mild cleaning
solution that is not harmful to plastics.
Do not use aromatic hydrocarbons or chlorinated solvents for
cleaning. They can damage the plastic materials used in the
Product.

Connect to Mains Power

To prevent shock hazard, connect the factory-supplied three-
conductor mains power cord to a properly-grounded power
outlet. Do not use a two-conductor adapter or extension cord,
as it will break the protective ground connection. If a two-
conductor mains power cord must be used, a protective
grounding wire must be connected between the ground
terminal and earth ground before you connect the mains power
cord or operate the Product.

Connect a 5725A Amplifier

The 5730A Calibrator provides an interface connector for the Fluke 5725A Amplifier.
Designate the active amplifier for voltage and current boost in the Setup Menu, as
detailed in Chapter 4 of the Operators Manual. Refer to the 5725A Instruction Manual for
the installation procedure.

Connect a 52120A Amplifier

The 5730A Calibrator provides an interface connector for the Fluke 52120A
Transconductance Amplifier. Designate the active amplifier for current boost in a Setup
Menu, as detailed in Chapter 4 of the Operators Manual. Refer to the 52120A Users
Manual for the installation procedure.

Front-Panel Features

Front-panel features (including all controls, displays, indicators, and terminals) are shown
in Figure 3. Each front-panel feature is briefly described in Table 5.
Caution
Warning
Multifunction Calibrator
Clean the Exterior
15