Options And Accessories; Introduction; Wideband Ac Voltage Module (Option 5730A/03 Or 5730A/05); Accessories - Fluke 5730A Operator's Manual

Introduction

This chapter describes options and accessories available to enhance the capabilities of the
5730A Calibrator. Chapter 4 contains instructions for operation of the Calibrator with the
options and accessories described here. To order options or accessories, call or write to a
Fluke Calibration Service Center.
Wideband AC Voltage Module (Option 5730A/03 or
5730A/05)
The Wideband AC Voltage Module (Option 5730A/03 or 5730A/05) is used to
calibrate RF voltmeters, and can be installed in the Calibrator. The Module
frequencies range from 10 Hz to 30 MHz (5730A/03) or 50 MHz (5730A/05). It is a
highly accurate, low-noise, ac voltage source that maintains excellent flatness. The
module sources its output through a coaxial connector into a 50 Ω load, and this
output can be from within any of seven ranges of values, from 300 µV (-57 dBm) to
3.5 V (+24 dBm), selected in either volts or dBm.
The wideband module also functions with the Calibrator edit controls. This will let the
display show the error of a wideband meter in percentage of output or decibels.

Accessories

Included with the wideband module are a Type "N" output cable, 50 Ω terminator, an
N(f) to BNC(m) adapter, and a BNC(f) to double banana plug adapter. The wideband
module is calibrated to the end of its standard equipment output cable.

Options and Accessories

Chapter 8
8-1