Fluke 5730A Operator's Manual page 113

Table 6-4. Command Summary by Function (cont.)
Calibration, Testing, and Diagnostics Commands for the Calibrator (cont.)
DIAGFLT
DIAGFLT?
OHMSREF?
*TST?
LOCAL
LOCKOUT
REMOTE
*ESE
*ESE?
*ESR?
EXPLAIN
FAULT?
*IDN?
ID52120?
ISCE
ISCE?
ISCR?
ISR?
ONTIME?
*OPT?
*SRE
*SRE?
STATE?
*STB?
UNCERT?
Sets the Calibrator response to faults in remote diagnostics
Returns the Calibrator response to faults in remote diagnostics
Returned calculated resistance reference (Main software revision H and
after)
Checks the nonvolatile storage area (calibration constants and instrument
settings).
Serial/USB/Ethernet Only Remote Commands
Puts the Calibrator into the local state
Puts the Calibrator into the local lockout state
Puts the Calibrator into remote state
Status Commands
Loads the Event Status Enable register
Reads the Event Status Enable register
Reads and clears the Event Status Register
Decodes a fault code by returning a brief description
Returns the most recent fault code from the fault queue
Returns Calibrator identification information
Returns the number of 52120s connected and their serial numbers
Loads the Instrument Status Change Enable register
Reads the Instrument Status Change Enable register
Reads and clears the Instrument Status Change Register
Reads and clears the Instrument Status Register
Returns the number of minutes since power-up this session
Returns a list of installed modules and attached amplifiers
Loads the Service Request Enable register
Reads the Service Request Enable register
Returns the long-term state of the Calibrator
Returns the status byte
Returns the calculated absolute uncertainty of the output
Remote Commands and Syntax
6
Commands
6-15