Kenwood TS-450S Instruction Manual page 70

(3) Operation
Before starting operation, adjust the SSB transmit output according to item 8 in the DSP-
100 instruction manual.
ESSB transmission
3
ECW or FSK transmission
2: 5
wud!
ee
o9
. Switch the transceiver POWER on, and then switch
the power to the DSP-100 on.
Press the DSP-100 TX switch.
Select either USB or LSB transceiver mode.
‚ Press the SEND/REC switch on the transceiver to
enable transmission or press the PTT lever on the
MIC.
. Speak into the microphone and adjust the DSP-100
MIC GAIN control so that the transceiver ALC meter
pointer does not exceed the ALC range.
. Switch the transceiver POWER on, and then switch
the DSP-100 on.
. Press the DSP-100 TX switch.
Set the transceiver mode to CW (or FSK).
. Press the SEND/REC switch on the transceiver to
enable transmission or depress the CW key in VOX.
Press and hold the CW key
. Adjust the DSP-100 CAR LEVEL control so that the
transceiver ALC meter pointer does not exceed the
ALC range.
. Switch the transceiver POWER on, and then switch
the DSP-100 on.
. Press the DSP-100 TX switch.
. Set the transceiver mode to AM.
. Press the SEND/REC switch on the transceiver to
enable transmission or press the PTT lever on the
MIC.
. Adjust the DSP-100 CAR LEVEL control so that the
transceiver PWR meter pointer indicates about half
the maximum output.
. Then, adjust the DSP-100 MIC GAIN control so that
the transceiver POWER meter pointer does not
exceed 80W.
Note
ineffective. Use the transceiver controls.
Bl Reception
=
1.
2.
3.
Switch the transceiver POWER on, and then switch
the DSP-100 on.
Press the DSP-100 RX switch.
Set the FILTER switch for the best frequency
response in each mode.
The selected frequency passband set with the
i a FILTER switch is used for transmission.