Setting The Paging Codes - Kenwood TM-241A Instruction Manual

5-10-1 Paging Code Memories 4. Press the DR/DT key. The first digit will flash.
(Not necessary this operation if you use DTMF
There are five(5) paging code memories. microphone)
Use
PA Store your individual ID code in memory.
PO Automatically stores the calling station's
code during reception. Can temporarily |
set code for the station. 1
P1~pPp3 | Stores group codes and local station 5. Set the desired number with the tuning contro! and
codes in memory. press the DR/DT key (or key 0 to 9 on the microphone
with DTMF). The first digit will be set, and the
5-10-2 Setting the Paging Codes second digit will flash.
1. Press the DR/DT key to enter the paging mode. The P
indicator will light.
2. Press the F key, then press the DR/DT key while the F
indicator is on. The code setting mode will be
entered and the memory channel indicator will flash.
6. Set the second and third digits with the tuning
control, and press the DR/DT key.
@er WeEcycr } 7. If, after 10 seconds, no key has been pressed, or a key
other than DR/DT or MR/M is pressed, the code will
3. Set the desired memory (0 to 3 or A) with the tuning be set.
control (or key 0 to 3 or A on the microphone [op-
tion] with DTMF).
42