Cable Routing - Platform Mount - Raymarine QUANTUM 2 Installation Instructions Manual

2. Cable routing for a scanner mounted on a platform, using the combined
power and data cable from an existing Raymarine® Digital Radar scanner
installation. For this, the A80308 Y-adapter accessory is required (not
supplied with the scanner).
3. Cable routing for a scanner mounted on a pole, using separate cables for
the power and data connection.
4. Cable routing for a scanner mounted on a pole, using the combined
power and data cable from an existing Raymarine® Digital Radar scanner
installation. For this, the A80308 Y-adapter accessory is required (not
supplied with the scanner).
Cable routing — platform mount
There are 2 typical cable routing scenarios for platform mount installations.
1. Using separate power and data cables.
2. Using an existing combined power / data cable from an older Raymarine®
Digital Radar scanner. In this scenario, the A80308 Y-adapter accessory
is required (not supplied with the scanner).
Note:
The routing options described and illustrated in this section assume that
a physical data connection is used between your Radar scanner and
multifunction display (MFD) / chartplotter. However, if the Radar scanner
is connected to your MFD via Wi-Fi, a physical RayNet connection is not
required.
46
Scenario 1: Using separate power and data cables
1. RayNet data connection. (This connection is not required if connecting to
the MFD via Wi-Fi.)
2. 12 V / 24 V power connection, via the supplied power cable.
Note:
• Not all Quantum™ radar variants are supplied with a RayNet cable. For
more information, refer to: p.14 — Document information
• For information on suitable accessory RayNet cables, refer to:
p.79 — Spares and accessories