Replacing Rubber Bumper; Replacing Shock Damper - Invacare AVIVA FX Series Service Manual

Hide thumbs Also See for AVIVA FX Series:
Table of Contents

Advertisement

Invacare® AVIVA™ FX Series
Removing Engaging Lever and Cap
1. Remove screws C and D securing engaging lever cap
A to engaging lever B.
2. Remove engaging lever cap.
3. Remove set screw E from engaging lever.
4. Remove engaging lever from motor F.
Installing Engaging Lever and Cap
1. Install engaging lever B onto motor F by securing
engaging lever to motor with set screw E. Tighten to
6.2 Nm.
2. Install engaging lever cap A onto engaging lever.
Apply thread locking adhesive on screw C and tighten
to 1.7 Nm.
Tighten screw D to secure engaging lever cap to
engaging lever.

6.7.6 Replacing Rubber Bumper

CAUTION!
Risk of Crushing to Hands and Feet by Weight of Component
Heavy components may cause injury or damage if dropped or not properly secured.
– Pay attention to hand and feet.
– Use proper lifting techniques.
– Properly secure heavy equipment or components when servicing.
CAUTION!
Risk of Uncontrolled Movement of Mobility Device
Uncontrolled movement of the mobility device can cause injury or damage.
– Power down mobility device.
– Engage drive.
– Before raising mobility device, secure wheels by blocking them with wedges.
– Prevent the mobility device from tipping by propping it up on wooden blocks which are long and wide enough
under the battery case. If the wooden blocks are too short or too high, the mobility device can still tip.
10 mm socket wrench
1. Loosen nut B securing rubber bumper H to frame.
2. Compress rear suspension arm A.
3. While compressing rear suspension arm, remove
rubber bumper by grabbing nut and sliding bumper
out trough slot in battery box tab.
4. Install parts in reverse order.
Tighten the hardware as listed below:
Nut B securing rubber bumper to 8.5 Nm

6.7.7 Replacing Shock Damper

CAUTION!
Risk of Crushing to Hands and Feet by Weight of Component
Heavy components may cause injury or damage if dropped or not properly secured.
– Pay attention to hand and feet.
– Use proper lifting techniques.
– Properly secure heavy equipment or components when servicing.
30
Fig. 6-23
A
B
C
Fig. 6-24
1675507-A

Advertisement

Table of Contents
loading

Table of Contents