Page 1
® ®3 Invacare Action Junior SERVICE MANUAL (MAINTENANCE AND ADJUSTMENT) The procedures in this manual MUST be performed by a qualified technician. 1638509-E...
Page 2
TABLE OF CONTENTS TABLE OF CONTENTS SECTION 1—TROUBLESHOOTING AND MAINTENANCE ............4 General information ........................4 Troubleshooting ..........................4 Maintenance Guidelines ......................4 Tightened Torques ........................5 Suggested Maintenance Procedures ..................5 Stability Warning ......................... 6 SECTION 2—FRONT HANGERS ....................7 Adjusting Footrest Height ......................
SECTION 4—SEAT/BACK Removing/Installing Standard Back Upholstery NOTE: For this procedure, refer to FIGURE 4.4. Removing Back Upholstery NOTE: To Install the Back Upholstery, reverse this procedure. 1. Remove the back-canes. Refer to Removing Back-Canes paragraph. 2. Remove the mounting screw that secures the back upholstery to the back-canes. Refer to Detail “A”.
SECTION 10— PERIODIC MAINTENANCE GUIDELINES SECTION 1 0 — PERIODIC MAINTENANCE GUIDELINES NOTE: Always clean the wheelchair before any inspection/adjustment. Regular cleaning will reveal loose or worn parts and enhance the smooth operation of the wheelchair. Initial Inspection: Initial adjustments should be made to suit the personal body structure needs and preferences of the user: Inspect/Adjust Initially Wheelchair rolls straight (no excessive drag or pull to one side).
SECTION 10— PERIODIC MAINTENANCE GUIDELINES Inspect/Adjust Weekly Wheelchair rolls straight (no excessive drag or pull to one side). Quick-release axles lock properly (see page 27). Inspect for broken spokes. Adjustment/replacement. Wheel/fork assembly has proper tension when caster is spun. Caster should come to a gradual stop. ...
Page 50
SECTION 10— PERIODIC MAINTENANCE GUIDELINES Inspect/Adjust every twelve months (2) Wheel brake pivot point are free of wear and looseness. Clean upholstery and armrests. Sealed bearings and axle nut tension are correct. Wheel/fork assembly has proper tension when caster is spun. Caster should come to ...
Need help?
Do you have a question about the Action 3 Junior and is the answer not in the manual?
Questions and answers