Replacing Rubber Foot; Replacing Tie-Down Points - Invacare AVIVA RX Series Service Manual

1. Hold in place nut A on rear side of main frame. Loosen
and remove bolt C, washers B and nut A.
2. Repeat previous step for remaining screwed connections.
3. Remove bracket D including kerb climber.
4. Install parts in reverse order.
5. Test all functions.

6.8.3 Replacing Rubber Foot

1. Pull front part of old rubber foot B off kerb climber A in forward direction.
2. Place rear part of new rubber foot over kerb climber.
3. Push front part of new rubber foot over kerb climber.

6.8.4 Replacing Tie-Down Points

The mobility device can be fitted with two additional tie-down points for easier access. If these points are retrofitted, the
existing tie-down points on the front of the main frame must not be used anymore.
• 5 mm Allen key
• 13 mm wrench
1654647-A
Fig. 6-19 For better view only the bracket is shown.
Service
35