Table of Contents
Advertisement
Invacare® AVIVA™ FX Series
Installing Rear Shroud
1. If lights are present, connect front lights connector E
and light power cable connector F to rear lighting
harness G inside of rear shroud. Ensure they are
connected in proper location, marked by labels on
each cable.
2. Install keyhole C in bottom of rear shroud onto pegs
D on battery box, one side at a time.
3. Rotate top of rear shroud forward under bumper
screws H, if present.
Route cables:
•
Route motor cables I and light cables J through top
opening in both sides of rear shroud.
•
Group other cables K and route through front right
opening in top shroud.
4. Push rear shroud down to engage rear shroud with
pegs on battery box.
5. Rotate top of rear shroud all the way forward and push
down to engage securely with battery box.
6.6.2 Replacing Rear Top Shroud
•
Flat screwdriver
1. Make sure mobility device is powered down.
2. Remove rear shroud. Refer to 6.6.1 Replacing Rear
Shroud, page 21.
3. Remove star washers C.
4. Disengage rear top shroud A from rear shroud B by
pulling rear top shroud up.
5. Installation of rear top shroud takes place in reverse
order.
22
Fig. 6-3
Fig. 6-4
A
B
C
Fig. 6-5
1675507-A
Advertisement
Table of Contents
