Advertisement
EN
Mounting MultiFrame
1.
First determine where the MultiFrame should hang. The distance bet-
ween the MultiFrames depends on the type of milking parlour. The posi-
tion measurements can be found in the drawing of the milking parlour
(fig. 3).
2.
Once the distance has been determined, the holes can be drilled accor-
ding to the dimensions as shown in the drawing (fig. 1).
3.
Then mount the MultiFrame on the wall. (Mounting material is not inclu-
ded).
X
1
X
= depending on the size of the cow, measure this (total ± 2000 mm -
± 2400 mm).
= 2400 mm
Mounting feed trough
1.
Install the feed trough in the MultiFrame. The feed trough is easy to place
in the frame by sliding it obliquely below the 2 vertical tubes which are
welded to the ring. When the edge of the feed trough is placed under the
vertical tubes, the feed trough can be placed on the ring. The feed trough
is now secured on one side.
2.
Secure now the other side of the feed trough with the
supplied mounting material as shown in figure 5.
3
Hanskamp AgroTech BV (the Netherlands)
1
X
= 2000 mm
4
5
There are two types of feed troughs available. The perfora-
ted feed trough (art. no. 007-522-000) and the traditional
feed trough with 1 hole (art. no. 007-522-001).
2 - 8
www.hanskamp.nl/en
2
1
3
<1.5 m
MultiFrame is not suitable for a stand
width of less than 1.5 m.
007-522-000
MultiFrame
075-000-000
2
4
6
007-522-001
Advertisement
