Table of Contents
Advertisement
1.
Using a torque driver, remove the two screws holding the bracket in place.
2.
Separate the bracket from the ConnectX-6 card.
Be careful not to put stress on the LEDs on the adapter card.
3.
Save the two screws.
Installing the New Bracket
1.
Place the bracket onto the card until the screw holes line up.
Do not force the bracket onto the adapter card.
2.
Screw on the bracket using the screws saved from the bracket removal procedure above.
Use a torque driver to apply up to 2 lbs-in torque on the screws.
Installation Instructions
This section provides detailed instructions on how to install your adapter card in a system.
Choose the installation instructions according to the ConnectX-6 configuration you have purchased.
OPNs
MCX651105A-EDAT
MCX653105A-HDAT
MCX653106A-HDAT
MCX653105A-ECAT
MCX653106A-ECAT
MCX653105A-EFAT
MCX653106A-EFAT
MCX683105AN-HDAT
Installation Instructions
PCIe x8/16 Cards Installation Instructions
37
Advertisement
Table of Contents
Troubleshooting
