Table of Contents
Advertisement
2. Separate the bracket from the ConnectX-4 Lx card.
Be careful not to put stress on the LEDs on the adapter card.
3. Save the two screws.
Installing the New Bracket
1. Place the bracket onto the card until the screw holes line up.
Do not force the bracket onto the adapter card.
2. Screw on the bracket using the screws saved from the bracket removal procedure above.
Use a torque driver to apply up to 2 lbs-in torque on the screws.
Installation Instructions
This section provides detailed instructions on how to install your adapter card in a system.
Please note that the following figures are for illustration purposes only.
1. Before installing the card, make sure that the system is off and the power cord is not connected
to the server. Please follow proper electrical grounding procedures.
2. Open the system case.
3. Place the adapter in an available PCI Express slot.
16
Advertisement
Table of Contents
Troubleshooting
