Table of Contents
Advertisement
_ _ _ _ _ _ _ _ _ _ _ Chapter 2
Set-up
■ Loading
the PC Card
Set the CAM/OFF/PLAY switch
to
OFF before inserting or removing the PC card.
*
Do not use PC cards other than that specified (MP-HD260A).
*
Do not attempt to attach an adhesive tag, etc. to the PC card to remove it easily. If the PC card is removed while
the MP-EG lA is operating, it could result in malfunction.
0
Open the lid of the PC card insertion slot.
Use a coin, etc. to loosen the screw and remove the lid.
e
Insert the PC card.
With the card surface up, insert the PC card until it is fixed securely
into the slot.
e
Close the lid of the PC card slot.
Attach the lid over the slot and tighten the screw.
··--":I
Set the CAM/OFF/PLAY switch to OFF and loosen the screw to
remove the lid. Lay the MP-EG1A on its side in a horizontal place
and push the eject lever. The PC card will be removed.
*
Be careful not to drop the PC card as this could damage it.
- - Eject lever
See ''Troubleshooting Guide" on page 91, or check the following two items:
Screw
•
If the CAM/OFF/PLAY switch is set to CAM or PLAY, the eject lever will not move. Set itto OFF,
and power the MP-EG1A from the charged battery pack or AC adapter/charger.
•
If the PC card becomes hot after the MP-EG1 A is used for a long time, the eject lever will not
work even if the CAM/OFF/PLAY switch is set to OFF, for safety reasons. In this case, leave
the MP-EG1A as it is for 10-20 minutes to cool the PC card. When the temperature is low
enough, the eject lever can be operated.
Advertisement
Table of Contents
