Step 3. Add The Battery To The Handset - VTech VT 9125 User Manual

Setting Up Your Phone

STEP 3. ADD THE BATTERY TO THE HANDSET

If this is the first time you are installing the battery, the
battery cover is not on the handset. It is located in your
accessory packet. Skip step 1.
1. Remove the battery cover by sliding it out.
2. Locate the battery connector inside the battery well.
If you are replacing a dead battery, remove the old
battery by pulling firmly on the battery cords.
3. Insert the battery plug into the connector. It is polarized
and only inserts in one direction.
4. Place the battery in the battery well. Make sure that the
battery cords are on top of the battery. Do not lay the
battery on top of the battery cords otherwise you might
pinch the battery cords.
5. Replace the battery cover by sliding it in.
6. Replace the handset on the base and let the battery
charge for full 14 hours before using.
To save battery life, it is recommended to leave the handset
out of the base after the handset battery has been fully
charged. Return the handset to the base and recharge the
battery when the BATTERY icon comes on.
To ensure proper charging clean the charge contacts
on the handset and base with a soft cloth periodically.
Ni-Cd
or
IMPORTANT NOTE:
SPENT NICKEL-CADMIUM RECHARGEABLE
BATTERIES MUST BE RECYCLED OR
DISPOSED OF PROPERLY IN COMPLIANCE
WITH ALL APPLICABLE LAWS.
FOR DETAILED BATTERY RECYCLING
INFORMATION, CONTACT THE
RECHARGEABLE BATTERY RECYCLING
CORPORATION AT 1-800-822-8837
- 6 -