Add And Register A Handset - VTech LS640V-1F User Manual

Getting started

Add and register a handset

You can add new LS6405/LS640V handsets (purchased separately) to your
LS6425/LS6426/LS6475/LS6476/LS642V telephone system. Each handset must
be registered with the telephone base before use. When first purchased, each
handset displays Put HS on BASE to register. You may need to charge the
handset before registering it to the telephone base. For more details on battery
charging, see page 3.
To register a handset:
1. Make sure the handset is out of the telephone base
or handset charger and shows
Put HS on BASE to register and then place the
handset in the telephone base.
The handset displays Registering...Please wait
2.
and the red
IN USE
turns on. It takes about 90 seconds to complete the
registration process. The handset displays
HANDSET X Registered (X represents the
registered handset number). The IN USE light turns
off and the handset beeps when registration completes.
If registration fails, the system will automatically try to
register again. If registration fails after the third try, the
handset displays Registration failed then
Put HS on BASE to register. This may take up to five
minutes to occur.
To reset the handset, remove it from the telephone base.
When the handset displays Put HS on BASE to register,
try the registration process again.
After registration, the date and time need to be reset.
light on the telephone base
4