GREE ELECTRIC GWH07AGA-K6DNA1A/O Service Manual page 56

Service Manual
be adjusted and it won't be displayed under AUTO mode; when
pressing "+" and "SET" buttons simultaneously under off status for
consecutive 5s, the set temperature can be adjusted under AUTO
mode. After setting is succeeded, the set temperature on the
remote controller flashes for 3 times.
Replacement of batteries in remote controller
signal sender battery
reinstall
remove
Cover of battery box
1. Press the back side of remote controller marked with " ", as
shown in the fig, and then push out the cover of battery box along
the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the
position of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
NOTE:
● During operation, point the remote control signal sender at the
receiving window on indoor unit.
● The distance between signal sender and receiving window
should be no more than 8m, and there should be no obstacles
between them.
● Signal may be interfered easily in the room where there is
fluorescent lamp or wireless telephone; remote controller should
be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is
required.
● When you don't use remote controller for a long time, please
take out the batteries.
● If the display on remote controller is fuzzy or there's no display,
please replace batteries.
Technical Information
53