Table of Contents
Advertisement
Water inlet tube
Use the new water inlet hose supplied with your machine. Do not re-use old hose sets.
• Before you connect the fill hose to the appliance; let some water flow through to ensure all debris is removed.
• We suggest you connect the fill hose and open the water valve before
pushing the appliance into position.
• Connect the hose directly to the water inlet tap. The pressure supplied with
the tap should be a minimum of 0.03MPa and a maximum of 1PMa. If the
pressure exceeds 1PMa, a pressure relief valve must be fitted between the
connection.
• After the connections are made, turn the tap on fully and check for water
leaks. Always turn off the water inlet tap after a wash program has finished.
• If the water hose is damaged, immediately close the water supply valve and disconnect the mains plug from
the mains socket.
• Check for leaks during and after installation and after first use.
Drain hose
Connect the water drain tube directly to water drain tube or to the sink outlet spigot. This connection should be
minimum 50cm and maximum 100cm from the floor on which the dishwasher is placed.
max.
1000mm
min.
500mm
Important: Items will not wash properly if a drain hose longer than 4m is used.
*
max.
100mm
*
min.
300mm
0.5 - 1.1m
Exclusive to Howdens
Cold water supply
10-80 lpm.
4.0m +
7
Advertisement
Table of Contents
