Installation Instructions - Galanz GLFW22WEA5A Instruction Manual

INSTALLATION INSTRUCTIONS

WARNING
Certain internal parts are intentionally not grounded and
may present a risk of electric shock only during servicing.
Service Personnel-Do not contact the following parts while
the appliance is energized: Electrical Valve, Door Lock,
Drain Pump, UI Board, Motor Controller and Reactor.
Unpacking
Remove all the packing(including the
foam base) or the vibration and noise
may occur.
Dispose all the wrappage safety and
keep them out of the reach of children.
Danger of suffocation!
It is normal that water drops appear on
the packing plastic bag and the door glass, which are resulted
from the water left in the tub for checking out.
Accessories
Make sure that you have received all of the items shown below.
Accessories Name
Inlet hose
transit bolts
caps
Qty.
Accessories Name
"U" piece
1
Manual
4
Removing transit bolts
Remove all the transit bolts at the
rear of the machine with tools.
Plug the holes with the transit
bolts caps supplied.
Keep the transit bolts for future
transportation. Whenever the
machine is transported, the
transit bolts must be refitted.
Strong vibration, noise or failures may occur if
NOTE
the transit bolts are not removed.
Installation place requirement
A concrete floor is the most suitable
installation surface for a washing
machine, being far less prone to
vibration during the spin cycle than
wooden floorboards or carpeted
surface.
The machine must be level and
securely positioned. The distance between the machine and wall
must be more than 10 cm .
Qty.
To avoid vibrations during spinning. the machine should not be
installed on soft floor coverings.
Level adjustment
1
The machine must stand perfectly level on all four feet to ensure
safe and proper operation. Incorrect installation may increase
1
electricity and water consumption and may cause the machine
to move about.
Transit bolts
7