Galanz GLFW22WEA5A Instruction Manual page 20

MAINTENANCE INSTRUCTIONS
The motor "E05" is
does not on the
work. screen.
There is a "E06" is
heating tube on the
fault. screen.
There is a "E07" is
temperature on the
sensor fault. screen.
Specification and Parameters
Washing/spin Capacity (cu. ft.)
Rated Voltage (AC V/Hz)
Rated power (W)
Weight (kg)
Water pressure (MPa)
Dimensions (W*D*H)
Note:
Data can vary from the nominal values given depending on water pressure,
water hardness, water inlet temperate, room temperature, type and volume
of load, fluctuations in the electricity supply and any extra options seleceted.
18
1. The connection between the
motor and wire is not secure.
2. The motor is protected
because of over-heat.
3. The motor is damaged.
1. The connection between
the heating tube and wire is
not secure.
2. The heating tube is
damaged.
1. The connection between the
temperature sensor and wire is
not secure.
2. The temperature sensor is
damaged.
2.2
120V, 60Hz
1200
69/74
0.02-0.8
595 X 665 X 845mm
1. Check the connection and
ensure it is secure.
2. Check if the machine is
overloaded. Switch off the
machine, and retry when the
motor becomes cool.
3. Change the motor.
1. Check the connection and
ensure it is secure.
2. Change the heating tube.
1. Check the connection and
ensure it is secure.
2. Change the temperature
sensor.