TurboChef ECO ST Owner's Manual page 24

34 LEGACY CONTROLLER OPERATION
Edit Settings
From the Item Editing Options screen (page 32), select "Edit Settings." From the
Edit Settings screen the operator can:
- Edit % Air Time
- Edit % Air
- Edit % Microwave
- Edit Cook Time
- Name an Item
- Run a Test Cook Cycle
Edit % Time
Touch a % Time icon to change, enter the new percentage, and touch "ENTER. " % Time can be set from
0-100% for each event. The sum of all events must be 100. Once all changes are made, touch "SAVE."
Edit % Air
Touch the % Air to be changed and adjust it using the sliding bar that appears below the grid. % Air
determines the amount of airflow. The more air, the more the product will brown or crisp. % Air can be set
from 10-100% in 10% increments. Once all changes are made, touch "SAVE."
Edit % Microwave
Touch the % Microwave to change and adjust it using the sliding bar that appears below the grid. %
Microwave can be set from 0-100% in 10% increments. For example, 50% means the microwave system will
remain on for five continuous seconds for every ten seconds during the cook cycle. Once all changes are
made, touch "SAVE. "
Edit Cook Time
Touch the current cook time. The maximum allowable cook time is 15 minutes. Using the number keypad,
enter the cook time and touch "ENTER." Once all changes are made, touch "SAVE. "
Name an Item
Touch the current name. Using the keypad, input the name and touch "ENTER. " Once all changes are
made, touch "SAVE. "
NOTE: The field allows for a maximum of 16 characters.
NOTE: Touch the "123" icon to access numbers and symbols.
NOTE: Touch the
NOTE: Touch the Alt icon to show special characters.
Run a Test Cook Cycle
If desired, touch "Cook" to perform a test cook.
NOTE: The oven may require additional warm-up time before a test cook can be performed.
ECS-1001 / Rev E / August 2023
icon to change case between:
- Uppercase, blue icon
- Lowercase, gray icon
35
ECS-1001 / Rev E / August 2023