Table of Contents
Advertisement
6
CLEANING
Daily Maintenance
Follow the steps below when cleaning your ECO
ST oven. Use only TurboChef ®-approved cleaning
chemicals. The use of any other cleaning products
may damage critical oven components, resulting in a
non-warranty service call.
Step 1: Prepare the Oven
WARNING: The oven operates at approximately 500°F (260°C) and may cause injury if
not allowed to cool properly.
•
Turn off the oven by touching the Off icon.
•
Slightly open the oven door.
Step 1
•
Cooling takes approximately 30 minutes. DO NOT proceed to Step 2 until the oven
displays "ready to clean. "
Step 2: Remove the Cook Plate and Lower Jetplate
WARNING: Be sure the oven interior is cool before removing these items.
•
Remove the cook plate from the oven (Step 2, Fig. A).
Step 2 (Fig A)
•
Loosen the bottom jetplate thumbscrew.
•
Lift the front of the bottom jetplate and pull it out from the cavity (Step 2, Fig. B).
Step 3: Clean the Lower Jetplate and Cook Plate.
•
Spray jetplate and cook plate with oven cleaner, scrub with scrub pad.
•
Rinse with water and dry with clean towel.
Step 2 (Fig B)
Step 4: Remove the Lower Crumb Tray and Clean the Air Filter
CAUTION: TurboChef does not recognize blocked air vents as a warrantable claim.
The filter must be cleaned regularly or replaced if damaged. During oven operation,
the filter must remain in place at all times.
•
Remove the lower crumb tray (under the door) by lifting straight up until the bolts are
free from the retaining slots.
Step 3
•
Empty and clean the lower crumb tray.
•
Remove the air filter from the front of the oven. Rinse the air filter with hot water.
•
Allow the air filter to dry completely.
CAUTION: DO NOT operate the oven without the air filter in place.
Step 5: Wipe the Oven Interior
Step 4
• Use a food vacuum or damp towel to remove large particles from the oven cavity.
Step 6: Clean the Oven Interior
•
Spray TurboChef Oven Cleaner onto the top, bottom, and sides of the interior.
CAUTION: DO NOT spray Oven Cleaner into the holes on the back oven wall. Doing so
can damage critical oven components, resulting in a non-warranty service call.
Step 5
•
Allow Oven Cleaner to penetrate stains for five minutes.
•
Clean the oven interior with a nylon scrub pad.
Supplies and Equipment
TurboChef ® Oven Cleaner (Product Number:
105704), TurboChef ® Oven Guard (Product
Number: 105703), nylon scrub pad, cleaning towel,
disposable gloves, protective eyewear, dust mask
(optional).
* The ECO ST includes a standard oven cleaner kit with oven
guard. Product number 10571.
ECS-1001 / Rev E / August 2023
Step 6: Clean the Oven Interior, Continued
CAUTION: DO NOT attempt to scrub the upper jetplate (A). If food is stuck
to the oven ceiling, gently remove it without applying pressure to the glass
plate. Breakage will result in a non-warranty service call.
Step 7: Clean and Dry the Oven Door
Step 6
CAUTION: DO NOT spray Oven Cleaner directly onto the oven door gasket
(B) or saturate it with water.
CAUTION: DO NOT scrub or attempt to clean the oven door gasket (B).
A
Doing so may cause the oven door to misalign, resulting in a non-warranty
service call.
Step 6, Continued
•
Clean oven door with Oven Cleaner and a nylon scrub pad.
•
Wipe the oven door with a damp towel.
Step 8: Rinse or Wipe the Oven Interior
CAUTION: DO NOT use a hose or water jet for cleaning. Doing so can damage
critical oven components, resulting in a non-warranty service call.
B
Step 7
•
Wipe down the oven interior with a clean damp towel.
•
Dry the oven interior with a clean towel.
CAUTION: DO NOT spray Oven Guard into the cavity, especially around the
holes on the back oven wall. Doing so can damage critical oven components,
resulting in a non-warranty service call.
Step 9: Reinstall Components
Step 8
•
Reinstall the lower jetplate and tighten the thumbscrew.
•
Reinstall the cook plate.
•
Close the oven door.
•
Reinstall the filter, or replace it with a new one if the mesh is deteriorated, has
large openings, or has started to dislodge from the frame.
Step 9
•
Reinstall the lower panel.
Step 10: Clean the Oven Exterior
•
Wipe the oven exterior with a clean, damp towel.
CAUTION: DO NOT spray chemicals into any openings, such as the vents below
the door or on the back panel. Doing so can damage critical oven components,
Step 10
resulting in a non-warranty service call.
•
The oven is ready to turn on.
7
ECS-1001 / Rev E / August 2023
Advertisement
Table of Contents
