List Of Uefi Events - Lenovo 7DCE Messages Manual

Table 3. Events organized by severity (continued)
Message String
Event ID
FQXSFMA0005N Memory is present within the system but could not be configured.
Please verify that the memory configuration is valid. [arg1]
FQXSFMA0008M DIMM [arg1] has failed the POST memory test. [arg2]
FQXSFMA0027K Invalid memory configuration (Unsupported DIMM Population)
detected. Please verify memory configuration is valid.
FQXSFPU0016N A processor within the system has failed the BIST.
FQXSFPU0017G A processor microcode update failed.
FQXSFPU0018N CATERR(IERR) has asserted on processor [arg1].
FQXSFPU0019N An uncorrectable error has been detected on processor [arg1].
FQXSFPU0030N A firmware fault has been detected in the UEFI image.
FQXSFPU0031N The number of POST attempts has reached the value configured in F1
setup.The system has booted with default UEFI settings. User
specified settings have been preserved and will be used on
subsequent boots unless modified before rebooting.
FQXSFPU0034L The TPM could not be initialized properly.
FQXSFPU4056M TPM/TCM card is changed, need install back the original TCM/TPM
card which shipped with the system.
FQXSFSM0008M Boot permission timeout detected.

List of UEFI events

This section lists all messages that can be sent from UEFI.
• FQXSFDD0001G: DRIVER HEALTH PROTOCOL: Missing Configuration. Requires Change Settings
From F1.
Severity: Warning
User Action:
Complete the following steps:
1. Go to F1 Setup > System Settings > Settings > Driver Health Status List and find a driver/controller
reporting Configuration Required status.
2. Search for the driver menu from System Settings and change settings appropriately.
3. Save settings and restart the system.
4. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFDD0002M: DRIVER HEALTH PROTOCOL: Reports 'Failed' Status Controller.
Severity: Warning
User Action:
Complete the following steps:
1. Reboot the system.
2. Reflash the adapter firmware.
148
ThinkSystem ST250 V3 Messages and Codes Reference
Severity
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error