Table of Contents
Advertisement
Table 2. Events organized by severity (continued)
Message String
Event ID
FQXSPUN0048I
The RAID controller in PCI slot [arg1] in optimal status.
FQXSPUN2009I
Sensor [SensorElementName] has deasserted.
FQXSPUN2012I
Sensor [SensorElementName] has deasserted.
FQXSPUN2018I
Sensor [SensorElementName] has deasserted the transition from
normal to non-critical state.
FQXSPUN2019I
Sensor [SensorElementName] has transitioned to a less severe state
from critical.
FQXSPUN2023I
Sensor [SensorElementName] has deasserted the transition to non-
recoverable.
FQXSPUN2049I
The RAID controller in PCI slot [arg1] is no longer in warning status.
FQXSPUN2050I
The RAID controller in PCI slot [arg1] is no longer in critical status.
FQXSPUP0002I
A firmware or software change occurred on system
[ComputerSystemElementName].
FQXSPUP4001I
Flash of [arg1] from [arg2] succeeded for user [arg3] .
FQXSPUP4002I
Flash of [arg1] from [arg2] failed for user [arg3].
FQXSPUP4006I
Auto promote primary XCC to backup is [arg1] by user [arg2] from
[arg3] at IP address [arg4].
FQXSPWD0000I
Watchdog Timer expired for [WatchdogElementName].
FQXSPWD0001I
Reboot of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
FQXSPWD0002I
Powering off system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
FQXSPWD0003I
Power cycle of system [ComputerSystemElementName] initiated by
watchdog [WatchdogElementName].
FQXSPWD0004I
Watchdog Timer interrupt occurred for [WatchdogElementName].
FQXSPBR4001I
Running the backup Management Controller [arg1] main application.
FQXSPCA0007J
Numeric sensor [NumericSensorElementName] going high (upper
non-critical) has asserted.
FQXSPCA0015J
Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPDM4002I
Device [arg1] VPD is not valid.
FQXSPEA0001J
Sensor [SensorElementName] has transitioned from normal to non-
critical state.
FQXSPEA0003J
Link down is detected on port [arg1] of the PCIe device [arg2].
FQXSPIO0014J
Bus [SensorElementName] is operating in a degraded state.
FQXSPIO2000J
The connector [PhysicalConnectorElementName] has been
disconnected.
FQXSPIO4001I
GPU Board Status was changed by [arg1] of [arg1].
FQXSPMA0010J
[PhysicalMemoryElementName] on Subsystem
[MemoryElementName] Throttled.
22
ThinkSystem ST250 V3 Messages and Codes Reference
Severity
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Advertisement
Table of Contents
