Initial Set-Up; Ring Type Programmi; Security Code Programming - VTech 900i User Manual

INTEGRATED TELEPHONE ANSWERING DEVICE (ITAD) OPERATION
PLAY
• The PLAY key is used to begin
playback of all messages/memos
(new and old) in the current mailbox
selection (the default mailbox
selection is All ).
• This key is also used to play the
current announcement message by
pressing and holding it for more than
2 seconds.
SKIP
• The SKIP key advances to the
beginning of the next message during
message playback.

INITIAL SET-UP

Press the SETUP key for more than 2
seconds to enter the set-up mode or
until it beeps once. Here you can set
the ring type, security code, time/day
and mailbox programming as follows.
Ring Type Programming
The ITAD has 3 ring type settings:
2 rings The incoming call is
answered after 2 rings.
4 rings The incoming call is
answered after 4 rings.
Toll Saver The incoming call is
answered after 2 rings only
if there are new messages/
m e m o s p r e s e n t i n
m e m o r y ; o t h e r w i s e ,
answers call after 4 rings.
Thus, if Toll Saver is active
and your ITAD rings 3
times when you call, you
can hang-up to avoid any
long distance charges.
To change ring type setting:
1. Press and hold the SETUP key for
2 seconds. The ITAD will beep and
the LCD will display "rt" (ring type)
and the current ring type setting.
2. Use the REPEAT and SKIP keys to
scroll to the desired ring type.
Forward selection is in the following
order 2 rings, 4 rings, Toll saver.
3. Press the SETUP key to exit ring
type programming mode, and
a d v a n c e t o s e c u r i t y c o d e
programming, or press the STOP
key to exit the set-up mode, and
return to standard operation mode.

Security Code Programming

The security code programmed into
the ITAD is used to gain access to the
functions from remote locations.
The security code default setting is 99 .
23