Axis M5075-G User Manual page 59

AXIS M5075-G PTZ Camera
Learn more
Note
If the Z-Wave device is not found, the adding process is terminated automatically.
To see the detailed status information of the added Z-Wave device, expand the device information in the device management list.
Note
Status information for an added Z-Wave device varies depending on the device type. For more information, see the online
help .
You can set the product to trigger rules with specified Z-Wave trigger conditions. The available Z-Wave conditions and actions vary
depending on the added Z-Wave device type.
Add a Z-Wave device with SmartStart inclusion
You can add a Z-Wave device to the Z-Wave network with SmartStart inclusion. A Z-Wave device added to the SmartStart list is
automatically added to the device management list within 10 minutes of being powered on in the network vicinity.
1. Go to System > Z-Wave.
2. Go to SmartStart and click
3. Type the device specific key and any optional information.
4. Click OK.
Remove a Z-Wave device through inclusion/exclusion mode
Note
This is the recommended removal procedure.
1. Go to System > Z-Wave.
2. Go to Device management and click
3. Set the Z-Wave device to be removed into inclusion/exclusion mode as described in its User Manual.
4. Wait until the removal process is finalized as indicated by a notification on the web page.
The Z-Wave device is now removed from the device management list.
Note
All product-related information in the removed Z-Wave device is deleted.
Note
If the Z-Wave device is not found, the removal process is terminated automatically.
Remove a Z-Wave device through forced process
There may be a communication fail, for example due to drained battery, so you may not be able to remove the Z-Wave device by
setting it to inclusion/exclusion mode. You can perform a forced removal of a Z-Wave device that shows the status Down in
the device management list.
1. Go to System > Z-Wave.
2. Go to Device management and expand the device information for the Z-Wave device to be removed.
3. Go to Node > Status and click
Add device information.
. The product starts looking for Z-Wave devices in the Z-Wave network.
.
59