Table of Contents
Advertisement
AXIS M5075-G PTZ Camera
Learn more
•
COMMAND_CLASS_INCLUSION_CONTROLLER
•
COMMAND_CLASS_INDICATOR_V3 (secured)
•
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2 (secured)
•
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V4 (secured)
•
COMMAND_CLASS_MULTI_CMD
•
COMMAND_CLASS_NETWORK_MANAGEMENT_BASIC_V2 (secured)
•
COMMAND_CLASS_NETWORK_MANAGEMENT_INCLUSION_V4 (secured)
•
COMMAND_CLASS_NETWORK_MANAGEMENT_INSTALLATION_MAINTENANCE_V4 (secured)
•
COMMAND_CLASS_NETWORK_MANAGEMENT_PROXY_V4 (secured)
•
COMMAND_CLASS_NODE_PROVISIONING (secured)
•
COMMAND_CLASS_POWERLEVEL (secured)
•
COMMAND_CLASS_SECURITY
•
COMMAND_CLASS_SECURITY_2
•
COMMAND_CLASS_SUPERVISION
•
COMMAND_CLASS_TIME
•
COMMAND_CLASS_TRANSPORT_SERVICE_V2
•
COMMAND_CLASS_VERSION_V3 (secured)
•
COMMAND_CLASS_ZWAVEPLUS_INFO_V2 (secured)
Note
The product supports COMMAND_CLASS_INDICATOR_V3, however there is no visible indicator.
Turn on Z-Wave
1. Go to System > Z-Wave.
2. Go to Gateway settings wireless I/O and turn on Z-Wave. You may need to wait for a few minutes for Z-Wave to
become active.
Add a Z-Wave device
Though not limited by the Z-Wave Plus v2 protocol, your product's event system allows you to add Z-Wave devices at any given time.
If the maximum number is reached, you need to remove a Z-Wave device before you can add a new one. See the product's datasheet
for information about maximum number of Z-Wave devices.
1. Go to System > Z-Wave.
2. Go to Device management and click
3. Set the Z-Wave device to be added into inclusion/exclusion mode as described in its User Manual.
4. If requested, enter the PIN delivered with the Z-Wave device, and click OK.
5. Wait until the adding process is finalized as indicated by a notification on the web page.
The added Z-Wave device is now visible in the device management list.
Add device. The product starts looking for Z-Wave devices in the Z-Wave network.
58
Advertisement
Table of Contents
