Axis M5075-G User Manual page 46

AXIS M5075-G PTZ Camera
The web interface
Add subscription: Click to add a new MQTT subscription.
Subscription filter: Enter the MQTT topic that you want to subscribe to.
Use device topic prefix: Add the subscription filter as prefix to the MQTT topic.
Subscription type:
• Stateless: Select to convert MQTT messages into a stateless message.
• Stateful: Select to convert MQTT messages into a condition. The payload is used as the state.
QoS: Select the desired level for the MQTT subscription.
MQTT overlays
Note
Connect to an MQTT broker before you add MQTT overlay modifiers.
Add overlay modifier: Click to add a new overlay modifier.
Topic filter: Add the MQTT topic that contains the data you want to show in the overlay.
Data field: Specify the key for the message payload that you want to show in the overlay, assuming the message is in JSON format.
Modifier: Use the resulting modifier when you create the overlay.
• Modifiers that start with #XMP show all of the data received from the topic.
• Modifiers that start with #XMD show the data specified in the data field.
Storage
Network storage
Ignore: Turn on to ignore network storage.
Add network storage: Click to add a network share where you can save recordings.
• Address: Enter the IP address or host name of the host server, typically a NAS (network-attached storage). We
recommend you to configure the host to use a fixed IP address (not DHCP since a dynamic IP address can change) or
that you use DNS. Windows SMB/CIFS names are not supported.
• Network share: Enter the name of the shared location on the host server. Several Axis devices can use the same
network share since each device gets its own folder.
• User: If the server requires a login, enter the username. To log in to a specific domain server, type
DOMAIN\username.
• Password: If the server requires a login, enter the password.
• SMB version: Select the SMB storage protocol version to connect to the NAS. If you select Auto, the device tries
to negotiate one of the secure versions SMB: 3.02, 3.0, or 2.1. Select 1.0 or 2.0 to connect to older NAS that don't
support higher versions. You can read more about SMB support in Axis devices here.
• Add share without testing: Select to add the network share even if an error is discovered during the connection test.
The error can be, for example, that you didn't enter a password even though the server requires one.
Remove network storage: Click to unmount, unbind, and remove the connection to the network share. This removes all settings
for the network share.
Unbind: Click to unbind and disconnect the network share.
Bind: Click to bind and connect the network share.
Unmount: Click to unmount the network share.
Mount: Click to mount the network share.
46