Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig . A) - Parkside 291869 Original Instructions Manual

Safety guidelines for battery chargers

This appliance may be used
■
by children aged 8 years and
above and by persons with lim-
ited physical, sensory or mental
capabilities or lack of experi-
ence and knowledge, provided
that they are under supervision
or have been told how to use
the appliance safely and are
aware of the potential risks . Do
not allow children to use the ap-
pliance as a toy . Cleaning and
user maintenance tasks may not
be carried out by children unless
they are supervised .
To avoid potential risks, dam-
■
aged mains cables should be re-
placed by the manufacturer, their
customer service department or
a similarly qualified person .
The charger is suitable for indoor use
only .
WARNING!
■ To avoid potential risks, damaged mains ca-
bles should be replaced by the manufacturer,
their customer service department or
a similarly qualified person .
■ 6 │ GB │ IE │ NI

Before use

Charging the battery pack (see fig . A)

CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger .
■ Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket . The control
LED lights up red .
♦ The green LED indicates that the charging
process is complete and the battery pack
ready .
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged .
♦ If the red and green control LEDs
flash, this means that the battery pack
broken .
♦ Push the battery pack
■ Never recharge a battery pack again immedi-
ately after rapid charging . There is a risk that
the battery pack will overheat and this will
reduce the lifespan of the battery .
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
to the high-speed
(see fig . A) .
flashes, this means
has overheated and
both
back into the appliance .
PSBSA 20-Li A1
is
is