Server Controls And Indicators; Front View - IBM X 330 Series Installation Manual

1. See your operating system documentation for the proper procedure to shut down
2. Press the power-control button on the front of the server. This will put the server
3. Disconnect the server from the power source.
Standby puts the server into a wait state. When in a wait state, the server is not
running the operating system, and all core logic is shut down except for the service
processor.
Complete the following steps to put the server into the Standby mode:
1. See your operating system documentation for the proper procedure to shut down
2. Press the power-control button on the front of the server.

Server controls and indicators

This section identifies the controls and indicators on the front and the back of your
server.

Front view

Power control
button
Power-control button: Press this button to manually turn the server on or off.
Power-on light: This green LED lights and stays on when you turn on your server and
blinks when the server is in standby mode.
Reset button: Press this button to reset the server and run the power-on self-test
(POST). You might need to use a pen or the end of a straightened paperclip to press
the button.
Select button/indicator: Press this button to select the server in the C2T chain. The
green LED on this button lights when the monitor, keyboard, and mouse are logically
connected to this server.
22
IBM xSeries 330 Type 8675: Installation Guide
the operating system.
Note: Each operating system is different. Some allow an immediate shutdown.
Others require an orderly shutdown procedure.
into Standby mode.
Note: After you turn off the server, wait at least 5 seconds before you turn on the
server again.
the operating system.
Note: Each operating system is different. Read all the documentation about
shutting down the operating system before continuing.
Select
button/indicator
(green)
Power-on
System error
light (green) light (amber)
Reset
button
CD activity CD eject button
light (green)
Diskette drive
activity light
(green)
Diskette eject
button