DeLonghi PrimaDonna Elite Experience Manual page 27

DISPLAYED MESSAGE
INSERT WATER SPOUT
INSERT MILK CONTAINER
INSERT INFUSER ASSEMBLY
PUSH
INSERT "MIX CARAFE"
WATER CIRCUIT EMPTY
PRESS OK TO START FILLING
PROCESS
POSSIBLE CAUSE
The hot water spout (C6) is not inserted
or is inserted incorrectly
The milk container (D) is not inserted
correctly.
The infuser (A19) has not been replaced
after cleaning.
The carafe (E) is not correctly in place
The water circuit is empty
REMEDY
Insert the water spout as far as it will go.
Insert the milk container as far as it will go (fig. 19).
Insert the infuser as described in section "18.9 Clean-
ing the infuser".
Insert the carafe and push as far as it will go
Press "
(C6) until it flows out normally. Delivery stops
automatically.
If the problem persists, make sure the water tank
(A16) is fully inserted.
30
" to deliver water from the spout