Table of Contents
Advertisement
4. "INSERT WATER SPOUT": Check that the hot water/steam
spout (C6) is inserted on the connection nozzle (A9) (fig.
7) and place a container holding a minimum of 100 ml un-
derneath (fig. 8);
5. "WATER CIRCUIT EMPTY PRESS OK TO START FILLING PRO-
CESS" appears on the display;
6. Press "
" to confirm. The appliance delivers water
from the spout (fig. 8) then goes off automatically.
The coffee machine is now ready for normal use.
Please note!
•
The first time you use the appliance, you need to make 4-5
cappuccinos before it starts to give satisfactory results.
•
The first time you use the machine, the water circuit is
empty and the appliance could be very noisy. The noise
becomes less as the circuit fills.
•
When making the first 5-6 cappuccinos, it is normal to hear
the noise of boiling water. After this, the noise becomes
less.
•
To improve the performance of your appliance, we recom-
mend installing a water softener filter (C4) as described
in section "21. Water softener filter". If your model is not
provided with a filter, you can request one from De'Longhi
Customer Services.
6. TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch
(A21) is pressed (fig. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
(A8) and is collected in the drip tray (A14) underneath. Avoid
contact with splashes of water.
7
As well as heating the boiler, this also heats the internal
circuits by circulating hot water.
The appliance is at temperature when the main screen (home-
8
page) appears.
7. TURNING THE APPLIANCE OFF
Whenever the coffee machine is turned off after being used to
make coffee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts
(A8). Avoid contact with splashes of water.
•
To turn the appliance off, press the
9).
•
The message "TURNING OFF, PLEASE WAIT" is displayed,
then the appliance performs a rinse cycle and goes off
(standby).
Please note!
If you will not be using the appliance for some time, first empty
the water circuit (see section "8.17 Emptying the circuit
unplug from the mains socket as follows:
•
first turn the appliance off by pressing the
(fig. 9);
•
release the main switch (A21) at the back of the appliance
(fig. 2).
Important!
Never press the main switch while the appliance is on.
8. MENU SETTINGS
8.1
Rinsing
Use this function to deliver hot water from the coffee spouts (A8)
and hot water/steam spout (C6), if inserted, to clean and heat
the appliance's internal circuit.
Place a container with a minimum capacity of 100ml under the
coffee and hot water spouts (fig. 8).
To enable the function, proceed as follows:
1. Press "
" (B2) to enter the menu;
9
•
To turn the appliance on,
press the
(A7-fig. 9). The message
"HEATING UP UNDERWAY
PLEASE WAIT" appears on
the display.
•
When heating is com-
plete, the message chang-
es to: "RINSING UNDER-
WAY, HOT WATER FROM
SPOUTS".
9
button (A7-fig.
button
i
"), then
button
Advertisement
Table of Contents
Troubleshooting
