Protections And Alarms - Tech Controllers EU-WiFi 8s mini User Manual

XII. PROTECTIONS AND ALARMS
The device supports the following cases within a zone:
Alarm
No communication with the
sensor/wireless regulator
Actuator alarm – ERROR #0 – low
battery
Actuator alarm - ERROR #1 – possible
damage of mechanical or electronic
parts
Actuator alarm - ERROR#2 – the
maximum actuator stroke has been
exceeded
Actuator alarm - ERROR#3 – too
little piston movement
Actuator alarm - ERROR #4 – no
return communication (to the
actuator)
Error #1 - Calibration error 1 –
Moving the screw to the mounting
position took too much time
Error #2 - Calibration error 2 – The
screw is maximally pulled out. No
resistance while pulling out
Possible cause
- No range
- No batteries
- The batteries are flat
ST-868 actuator alarms
- The actuator battery is flat.
Some parts have been damaged
- No piston controlling the valve
- Too big stroke (movement) of the
valve
- The actuator has been incorrectly
mounted on the radiator
- Inappropriate valve on the radiator
- The valve got stuck
- Inappropriate valve on the radiator
- Too little stroke (movement) of the
valve
- Out of range
- No batteries
ST-869 actuator alarms
- The limit switch sensor is damaged
- The actuator has not been screwed
to the valve or has not been screwed
completely
- The valve stroke is too big or the
valve dimensions are not typical
- Actuator current sensor is damaged
28
How to fix it
- Place the sensor/regulator in a
different place
- Insert batteries to the
sensor/regulator
The alarm is deactivated
automatically when the
communication is established.
- Replace the batteries
Call the service staff
- Install a piston controlling the
actuator
- Check the valve stroke
- Install the actuator correctly
- Replace the valve on the radiator
- Inspect the valve operation
- Replace the valve on the radiator
- Check the valve stroke
- The actuator is too far from the
controller
- Insert batteries into the actuator
After the communication is re-
established, the alarm is deactivated
automatically.
- Call the service staff
- Check if the controller has been
installed properly
- Replace the batteries
- Call the service staff