Changing Basic Settings - Bosch SM Series Instructions For Use Manual

basic
position
InfoLight
Signal volume
Factory setting (may vary depending on device type)
1
16.2 Change basic settings
Open the device door.
1.
press.
2.
Hold down program button A and
3.
Press until the display
shows H:xx.
Program button A and
4.
sen.
aThe program button A flashes and
the display shows H:04.
Press program button A repeatedly
5.
until the display shows the
desired setting.
Press program button C repeatedly
6.
until the display shows the
appropriate value.
Display text Selection
I:01 I:00 - I:01
1
b:02 b:00 - b:03
1
let go-
Description
Switch InfoLight on or off.
While the program is
running, a spot of light
appears on the floor below
projected onto the appliance
door. When installed high
with a flush furniture front,
the light point is not visible. If
the light spot flashes, the
appliance door is not fully
closed. When the light spot
on the floor is no longer
visible, the program is
finished.
The level "I:00" switches the
InfoLight off.
Control the signal volume.
Acoustic indication of the end
of the program with a signal
tone.
The level "b:00" switches off
the signal tone.
You can change several settings.
To save the setting, press .
7.
Close the device door.
8th.
Basic settingsde
45