Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bosch SMI43M15EU
Summary of Contents for Bosch SMI43M15EU
- Page 1 SM… SB…...
-
Page 3: Table Of Contents
Table of contents Intended use ....4 Utensils ....13 Not suitable. -
Page 4: Intended Use
Intended use Switching off automatically after Intended use the end of the programme ..22 Switching off the appliance..22 I n t e n d e d u s e Interrupting the programme . -
Page 5: Delivery
Safety instructions Delivery The electrical connection conditions must correspond 1. Check the packaging and with the specifications dishwasher immediately for on the dishwasher rating plate 92. damage caused in transit. Do not switch on a damaged If the power cord of this appliance, but contact your appliance is damaged, supplier. -
Page 6: In Daily Use
Safety instructions If you cannot obtain any In daily use information from Read and observe the safety the manufacturer, you must information and instructions not install the dishwasher for use on the packaging above or below these for cleaning and rinsing agents. appliances. -
Page 7: Damage
Safety instructions Deactivating the button lock: Warning Risk of injury! Hold down the button + for To prevent injuries, e.g. approx. 4 sec. until the caused by stumbling, open display goes out. the dishwasher only briefly When the programme ends in order to load and unload on the digital display), the the dishwasher. - Page 8 Safety instructions Ensure that children do not Warning place fingers in the tablet Risk of scalding! collecting tray 12. Small Open the door carefully when fingers could become the programme is still running. caught in the slots. There is a risk of hot water When opening and closing spraying out of the appliance.
-
Page 9: Protection Of The Environment
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c... -
Page 10: Overview Of Menu
Water softening system/Special salt Overview of menu 1. Find out about the hardness value of your tap water. Your water utility company will help you with this. The settings can be found in the 2. Set value can be found in the water individual chapters. -
Page 11: Using Special Salt
Water softening system/Special salt Using special salt Using detergents with salt component D e t e r g e n t s w i t h s a l t c o m p o n e n t Always refill with special salt immediately before switching on the If combined detergents with a salt appliance. -
Page 12: Rinse Aid
Rinse aid 3. Close cover until it clicks shut. Rinse aid 4. To prevent excessive foam formation R i n s e a i d during the next rinse cycle, remove any rinse aid which has run over with As soon as the rinse-aid refill indicator h is lit on the fascia, there a cloth. -
Page 13: Switching Off Rinse Aid Refill Indicator
Utensils Switching off rinse aid refill Recommendation: indicator Use only glasses and porcelain which the manufacturer designates as dishwasher-proof. If the rinse-aid refill indicator h is Use a detergent which protects impaired (e.g. when using combined utensils. detergents containing rinse aid component), it can be switched off. -
Page 14: Cups And Glasses
Utensils Cups and glasses Pans Top basket 1" Bottom basket 1b Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 12. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully. -
Page 15: Cutlery Basket
Utensils Cutlery basket F olding spikes * F o l d i n g s p i k e s You should always place cutlery * depending on model unsorted with the points downwards. The spikes can be folded down to To prevent injuries, place long, pointed improve arrangement of pans, bowls implements and knives on the knife... -
Page 16: Knife Shelf
Utensils Knife shelf * Top basket with side levers K n i f e s h e l f 1. Pull out the top basket 1" out. * depending on model 2. To lower the basket, press in the left Long knives and other utensils can be and then the right lever on the arranged horizontally. -
Page 17: Detergent
Detergent Adding detergent Detergent 1. If the detergent dispenser 9" is still D e t e r g e closed, press the lock 9* to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing up liquid. -
Page 18: Combination Detergent
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect... -
Page 19: Overview Of Programmes
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia. -
Page 20: Programme Selection
Additional options § Programme selection Half load * H a l f l o a d You can select a suitable programme If you have only a few items to wash according to the type of utensils and (e.g. glasses, cups, plates), you can degree of soiling. -
Page 21: Operating The Appliance
Operating the appliance Switching on the appliance Operating the appliance 1. Turn on the tap fully. 2. Switch on ON/OFF switch (. O p e r a t i i a n c e t h e a p p l The Eco 50°... -
Page 22: Timer Programming
Operating the appliance T imer programming * 1. Close the door. T i m e r p r o g r a m m i n g 2. Switch on ON/OFF switch (. 3. Hold down programme button # * depending on model and press START button P You can delay the start of the until : ... -
Page 23: Interrupting The Programme
Operating the appliance Interrupting the programme Intensive drying 1. Switch off ON/OFF switch (. The final rinse uses a higher temperature which improves the drying The LEDs go out. The programme is result. The running time may increase saved. slightly. (Caution if utensils are delicate!) If the door was opened on an appliance which has a warm water 1. -
Page 24: Cleaning And Maintenance
Cleaning and maintenance Warning – Health hazard Cleaning and Never use other domestic detergents, maintenance e.g. containing chlorine! C l e a n i a n d n a n c e m a i n t e Special salt and rinse aid A regular inspection and maintenance of your machine will help to prevent faults. -
Page 25: Spray Arms
Fault, what to do? 3. Remove any residue and clean filters Fault, what to do? under running water. 4. Re-install filter system in reverse F a u l t , w h a t d o ? sequence and ensure that the arrow Experience has shown that you can marks are opposite each other after rectify most faults which occur in daily... -
Page 26: Waste Water Pump
Fault, what to do? Waste water pump 6. Check impeller wheel and remove any foreign objects. 7. Place cover in the original position Large food remnants or foreign objects and press down until it engages which were not captured by the filters (click). -
Page 27: Fault Table
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display X lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min. - Page 28 Fault, what to do? Fault Cause Remedial action A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (. After a short time restart indicated on the digital occurred. display. the appliance. to : If the problem recurs, turn off the tap and pull out the mains plug.
- Page 29 Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid Refill rinse aid. in the dispenser. Programme selected without Select programme with drying (see drying. Overview of programmes, Programme sequence). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
- Page 30 Fault, what to do? Fault Cause Remedial action Food remnants Utensils placed too closely Arrange utensils with adequate clearance on the utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
- Page 31 Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
- Page 32 Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting Can be partly removed with machine brown), difficult to remove of ingredients from vegetables cleaner or by mechanical cleaning. Coatings to non-removable coatings (e.g. cabbage, celery, potatoes, are harmless.
- Page 33 Fault, what to do? Fault Cause Remedial action Rust spots on the cutlery. Cutlery not adequately rust- Use corrosion-resistant cutlery. resistant. Knife blades are frequently more severely affected. Cutlery will also rust if rusting Do not wash rusting parts. parts are rinsed at the same time (pan handles, damaged utensil baskets, etc.).
- Page 34 Fault, what to do? Fault Cause Remedial action Appliance stops Door not closed properly. Close the door. in the programme or Do not place utensils or fragrance Check whether rear panel is being pressed programme is interrupted. dispenser in the tablet collecting in, e.g.
-
Page 35: Customer Service
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service. -
Page 36: Delivery
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains. -
Page 37: Drinking Water Connection
Installation and connection Drinking water connection Setting hot water: 1. Close the door. 2. Switch on ON/OFF switch (. 1. Fasten the drinking water connection to the tap according 3. Hold down programme button # to the installation instructions using and press START button P the enclosed parts. -
Page 38: Electrical Connection
Installation and connection Electrical connection 4. Loosen fastening screws for the furniture parts. 5. If fitted, remove the base panel. Connect the appliance to an alternating current only, ranging from 6. Pull out the appliance, carefully 220 V to 240 V and 50 Hz or 60 Hz pulling the hose behind. - Page 40 *9000816844* 9000816844 en (9407) 640MA...