Intended use End of programme ....23 Intended use Automatic switch off / interior light . . 23 Switching off the appliance..24 I n t e n d e d u s e This appliance is intended for...
Safety instructions Delivery The electrical connection conditions must correspond 1. Check the packaging and with the specifications dishwasher immediately for on the dishwasher rating plate 9:. damage caused in transit. Do not switch on a damaged If the power cord of this appliance, but contact your appliance is damaged, supplier.
Safety instructions If you cannot obtain any In daily use information from Read and observe the safety the manufacturer, you must information and instructions not install the dishwasher for use on the packaging above or below these for cleaning and rinsing agents. appliances.
Safety instructions Deactivating the button lock: Disposal Hold down the button + for 1. Make redundant appliances unusable to prevent approx. 4 sec. until the subsequent accidents. display goes out. 2. Dispose of the appliance in a When the programme ends n environmentally friendly on the digital display), the manner.
Page 8
Safety instructions Ensure that children do not Warning place fingers in the tablet Risk of explosion! collecting tray 1:. Small Do not add any solvents fingers could become to the washing chamber. caught in the slots. Danger of explosion! When opening and closing the door on an eye-level Warning appliance, ensure that...
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c...
Water softening system/Special salt Appliance interior Water softening system/Special salt 1" Interior light * W a t e r s o f t e n i s y s t e m / S p e c i s a l t 1* Top basket To ensure good washing results, 12 Knife shelf *...
Water softening system/Special salt To change the setting: Using special salt 1. Press programme button 3. Always refill with special salt Each time the button is pressed, the immediately before switching on the set value increases by one level; appliance. This ensures that overrun when the value of : has been special salt solution is immediately...
Rinse aid Using detergents with salt Rinse aid component D e t e r g e n t s w i t h s a l t c o m p o n e n t R i n s e a i d As soon as the rinse-aid refill If combined detergents with a salt...
Rinse aid 2. Carefully pour rinse aid up To change the setting: to the max. mark in the filler opening. 1. Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to :...
Utensils Loading the dishwasher Utensils U t e n s i 1. Remove large food remnants. It is not necessary to prerinse utensils Not suitable under running water. 2. Place the utensils so that Cutlery and utensils made of wood. –...
Utensils Cups and glasses Heavily soiled utensils (pans) should Top basket 1* be placed in the bottom basket. The more powerful spray jet provides a better dishwashing result. Other examples, such as the best way of loading your dishwasher, can be found on our homepage as a free download.
Utensils E tagere * Small accessories holder * E t a g e r e S m a l l a c c e s s o r i e s h o l d e r The etagere and the space underneath * depending on model can be used for small cups and glasses Light-weight plastic accessories, e.g.
Utensils A djusting the height of the A d j u s t i n g t h e h e i g h t o f t h e b a s k e t basket * * depending on model If required, the height of the upper utensils basket 1* can be adjusted to provide more space for tall utensils...
Detergent Adding detergent Detergent 1. If the detergent dispenser 9* is still D e t e r g e closed, press the lock 92 to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing up liquid.
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect...
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options § Programme selection Half load * H a l f l o a d You can select a suitable programme If you have only a few items to wash according to the type of utensils and (e.g. glasses, cups, plates), you can degree of soiling.
Operating the appliance Switching on the appliance Operating the appliance 1. Turn on the tap fully. 2. Switch on ON/OFF switch (. O p e r a t i i a n c e t h e a p p l The Eco 50°...
Operating the appliance Remaining running time Automatic switch off after end display of programme or interior light* A u t o m a t i c s w i t c h o f f / i n t e r i o r l i g h t When the programme is selected, the * depending on model remaining running time of the...
Operating the appliance To change the setting: Interrupting the programme 1. Press programme button 3. 1. Switch off ON/OFF switch (. Each time the button is pressed, the set value increases by one level; The LEDs go out. The programme is when the value of : has been saved.
Cleaning and maintenance Intensive drying Cleaning and maintenance The final rinse uses a higher temperature which improves the drying C l e a n i a n d m a i n t e n a n c e result. The running time may increase A regular inspection and maintenance slightly.
Cleaning and maintenance Warning – Health hazard 3. Remove any residue and clean filters under running water. Never use other domestic detergents, e.g. containing chlorine! 4. Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after Special salt and rinse aid closing the filter system.
Fault, what to do? In this case: Fault, what to do? 1. First always disconnect F a u l t , w h a t d o ? the appliance from the power supply. Experience has shown that you can 2.
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display 8 lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min.
Page 29
Fault, what to do? Fault Cause Remedial action A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (. After a short time restart indicated on the digital occurred. display. the appliance. to : If the problem recurs, turn off the tap and pull out the mains plug.
Page 30
Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid Refill rinse aid. in the dispenser. Programme selected without Select programme with drying (see drying. Overview of programmes, Programme sequence). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 31
Fault, what to do? Fault Cause Remedial action Food remnants Utensils placed too closely Arrange utensils with adequate clearance on the utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 32
Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
Page 33
Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting Can be partly removed with machine brown), difficult to remove of ingredients from vegetables cleaner or by mechanical cleaning. Coatings to non-removable coatings (e.g. cabbage, celery, potatoes, are harmless.
Page 34
Fault, what to do? Fault Cause Remedial action Rust spots on the cutlery. Cutlery not adequately rust- Use corrosion-resistant cutlery. resistant. Knife blades are frequently more severely affected. Cutlery will also rust if rusting Do not wash rusting parts. parts are rinsed at the same time (pan handles, damaged utensil baskets, etc.).
Page 35
Fault, what to do? Fault Cause Remedial action Appliance stops Door not closed properly. Close the door. in the programme or Do not place utensils or fragrance Check whether rear panel is being pressed programme is interrupted. dispenser in the tablet collecting in, e.g.
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service.
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains.
Installation and connection Drinking water connection Warm water connection * W a r m w a t e r c o n n e c t i o n 1. Fasten the drinking water connection * depending on model to the tap according The dishwasher can be connected to the installation instructions using to cold or hot water up to max.
Installation and connection Electrical connection Removing the appliance Connect the appliance to an Also observe alternating current only, ranging from the sequence of worksteps here. 220 V to 240 V and 50 Hz or 60 Hz 1. Disconnect the appliance from via a correctly installed socket with the power supply.
Installation and connection Transportation Protection against frost P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e ) Empty the dishwasher and secure loose If the appliance is in a room where there parts.
Page 42
*9000786346* 9000786346 en (9311) 640MG...
Need help?
Do you have a question about the SMI65N05EU and is the answer not in the manual?
Questions and answers