Advertisement
Quick Links
Advertisement
Related Manuals for Teltonika FM6
Summary of Contents for Teltonika FM6
- Page 1 How to connect FMB6 to Carrier FMB6 freezers Professional tracker...
- Page 2 Main installation location is displayed in the picture below: Figure 1 Panel cover...
- Page 3 Remove the panel stickers marked in the picture: Figure 2 Fuse panel stickers location...
- Page 4 Unscrew the panel screws marked in the picture and open the panel cover: Figure 3 Location of the screws...
- Page 5 The picture below displays the location of the electric panel where connectors can be found: Figure 4 The main connector location...
- Page 6 All of the the connectors displayed in screenshot, find the marked connector: Figure 5 The main connector location...
- Page 7 The connector should have a cap attached as displayed in the close up screenshot, unclip the cap. Figure 6 The main connector cap...
- Page 8 The FMB6 devices can be installed in the panel as displayed in this example: Figure 7 An example of FMB6 device installed in the panel...
- Page 9 Device’s wires lead down through gasket to the connector as displayed below: Figure 8 An example of FMB6 device installed in the panel full view...
- Page 10 Connect the FMB6 wires to the main connector in the electric panel exactly as shown below. Wires marked in the screenshot (RS232 GND(Black), RS232 TX (Orange/Blue), RS232 RX(Yellow/Green)). Figure 9 The connection of the FMB6 device‘s wires to the main connector...
- Page 11 Make sure FM6 device is configured to receive data from “Carrier Freezer”. To do this, enter the configurator window, select RS232 \ RS485 section displayed in the screenshot below and configure accordingly (COM1 Settings, Mode “Carrier Freezer”, Baudrate: 9600) Figure 10 The configurator‘s RS232 \ RS485 settings section...
- Page 12 The screenshot below displays Freezer I/O parameters section, here you can set up your device to send required parameters. Figure 11 The configurator‘s Freezer I/O settings section...